|Page (1) of 2 - 12/06/01||email article||print page|
AutoCAD ZoneArray Command
Enter the type of array [Rectangular/Polar]
At the first prompt objects to form an array are selected. After each selection the prompt is displayed again. To terminate the selection an ENTER is given.
A rectangular and a polar array can be drawn.
The type of array to be drawn can be selected at the second prompt.
If is chosen for a rectangular array then the following prompts are displayed:
Enter the number of rows (---) <1>:
Enter the number of columns (|||) <1>
The number of rows and columns is entered at the third and the fourth prompt.
If the number of rows and columns is only 1 then no array can be drawn. The following prompt is displayed:
One-element array, nothing to do.
If an array can be drawn then the following prompts are displayed:
Enter the distance between rows or specify unit cell
Specify the distance between columns (|||):
At the fifth prompt a unit cell can be drawn by picking two points in the drawing area. After picking the first point the following prompt is displayed:
After picking the second point the array is drawn.
Also a distance can be entered. If the number of rows is more than 1 then the command asks for a distance between the rows. The same with columns.
Source:Digital Media Online. All Rights Reserved